- Messages
- 13,673
Lord Biltmore | Sky-Rider
Soft Light-weight light grey felt
4 3/4 crown as shaped (about 5 open)
1 inch silver grosgrain ribbon
2 1/2 brim with bound edge
Carter removable sweatband system
Second of the five Canadian hat stack. If yesterday I went with the hat that needed the least work… today is the one that probably needed/needs the most. However was likely one of the finest of the bunch when new. Which is why this one looks like it got some wear. Very dirty from doffing stains on the crown as well as what appears to have been a hole worn clear through the brim…. Probably from holding the hat between two fingers. It appears a repair was attempted at some point as the hole was held together with a glob of glue that is starting to fall off. I started off giving a good brushing to the felt..l followed by working over the felt with a dry hat sponge to try and remove some of the discoloration.
I then made my first attempt at repairing the patch. After sanding down the old glue patch. I used some ideas I got from Robert @belfastboy . I used sandpaper on the felt to collect my own loose felt. I sprayed some spray adhesive onto a paper plate and collected it onto a toothpick and slowly spread glue where it needed to go. Starting with the toothpick I dabbed loose felt into the glue area and continued to dab and pack and pat more loose felt into the blob of glue and felt. Let dry.. sand down and repeat.
The hat itself.. other than the 1 inch ribbon… has specs similar to the Stratoliner… it is a super light weight and very malleable felt. One very special feature it includes the Carter Cushioned Leather removable Sweat system that you see old old Stephen L Stetson
I’m not sure if I made it better or worse. LOL. I may continue to work on this as I may have better results with more patience and drying time.
Last edited:











